Jump to content

Quick Mill Vetrano 2B evo - float? No warning.


Recommended Posts

I got my machine a couple of months ago (with very little in the way of an instruction manual) but I was under the impression that there should be some sort of float in the water tank that triggers a warning when the tank is about to run dry? If so then I don't think mine is working....the machine regularly will just run dry in the middle of pulling a shot and lose pressure unless I physically check how much water is in the tank. I also can't see anything that resembles a float? Any advice from any fellow QM owners?

Link to comment
Share on other sites

I have a Verona, an earlier version of the Veterano.  The tank water level sensor is in the L/H side near corner of the water tank.

It consists of a white tubular float contained / retained by a S S bracket & screw. It actuates a sensor on the inside of the machine case.

If the level goes low it stops the pump / shot until tank refilled.



  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...