Search the Community
Showing results for tags 'feldfarb'.
Found 2 results
I am now printing two different clips for the Feldgrind, please see below. The 'Simple Clip': £4 inc postage This clip is good for use at home and will hold the handle against the body when storing your Feldgrind in your cupboard. Using this clip: Slot the clip onto the handle near the knob and slide down until the clip stops (dont push too hard). Place the nob resting on the shaft of the grinder, this will give you your level to move the rubber band to. Remove the handle and slot the clip under the band, then just pop the handle in place. The 'Secure Travel Clip': £6 inc postage This clip is super secure. It is designed to keep your lid secure and the handle in place when travelling. It needs to be removed before using the grinder as it obstructs the lid. Using this clip: You will find it a bit fiddly at first getting this on. The lid should be placed into the top of the clip before fitting the clip, then the whole thing pushed down onto the top of the Feldgrind, lift the rubber band to help the lower parts of the clip get under it and it should then push down. The handle should 'twist' in but dont force it, and when removing the handle you will need to lift the clips a little with your finger, just twisting the handle will break the clips. If you would like one please drop me a PM. If you want both clips its £9 including postage. Should you break or snap a clip contact me and I will send you a new one at cost (not much less than I sell em for).
A shiny brand new red Feldfarb arrived a couple of days ago. I'm delighted with the grinder but I wondered if my settings are a cause for concern. The manual recommends 1.6 to 1.10 for a good Aeropress setting but I have found this setting to produce particles that are way too fine for the Aeropress. A couple of days and more than a couple of handfuls of beans later, I find that 3.10 is giving me the grind size in the attached image. Just to clarify, that's three full turns of the adjustment control (from 0 right around to 0 again) then around to 10 once more. My brews are 90% Aeropress and 10% Chemex or pourer so I really only have need for coarse-ish settings. Did I miss something somewhere or do you think the grinder setting might be faulty in some way? Thanks in advance to more experienced users. .