Jump to content

Assaf Aman

New Members
  • Content Count

    16
  • Joined

  • Last visited

Community Reputation

1 Neutral

About Assaf Aman

  • Rank
    Lightly Roasted
  1. Hi Looking desperately for wiring diagram for my machine Anyone has?
  2. Thanks...the wire colors are all different...but Ill try to follow P2P
  3. Hi Thanks I checked...Unfortunately it only looks like it because of the photo perspective. The connector does not thouch the pipe fitting (actually its a few centimeters above it). It was a few milimeters from the coil...but not touching...I pushed the coil away just in case. As for isolation, you are absolutely right. I have a shrinking isolation which Ill use. Sad for me, no success for me yet with getting the machine to work
  4. Apologies for the capital letters...didnt know its not allowed. I will take some photos and share Thanks
  5. Hi Recently I did a small renovation to my machine. I replaced the steam pump, the safety thermostat and the solenoid when I power on the machine and before activating the pump, the fuse burns. I tried to disconnect the solenoid, put a new fuse and power on again. this time the fuse did not burn. Im not sure whats causing the problem. could be that one of the wires is not in place... does anyone have a wiring diagram of this machine? any idea what could be the problem? Thanks
  6. Just to verify... We are talking on the steam pump... Not the coffee pump... Its a dual heat exchange machine
  7. Thanks I ordered a new limit thermostat. I also took apart the solenoid and cleaned it internally. I suspect it is also faulty. if I take out the solenoid valve, to allow flow from the pump to the boiler, and try to blow air from the pump inlet, almost no air comes out from the outlet to the boiler, of course I close the valve side by one finger, so air will not go that way...
  8. Thank you so much so in this photo you can see the suspected element in the following picture, an alternative installation I found
  9. Hi thanks I would be glad to share photos but for some reason, specifically in this forum, I dont know how to do it Im not sure if I understand what is the limit stat...on each one of the boilers there are two round elements, one light brown rounded which is the thermostat, second black rounded one which I realized by trial and error, that is providing power to the boiler...is this the limit stat?
  10. Hi So... I checked the boiler nodes...looks OKI checked the thermostat for continuity ... seems OKThen I checked the load resistor ... looks broken ... it has no resistance at all... I understand that this element provides power to the boiler...I tried to locate the part number on the element but it got wiped out from wear... can you help with part number? B.T.W I saw in other forums that people are replacing this element with a safety thermostat like this one: https://www.drtradingshop.nl/en_GB/a-48797198/spare-parts-quickmill-3000-3002-3004/safety-thermostat-167-degr
  11. Yes Sir! I will do as you say and start with testing the thermoblock. can you please confirm the points I need to test between, as per the diagram I attached? Thanks
  12. Hi Dave Thanks for replying I understand I need to test between the two thermoblock nodes as marked in the drawing attached? what should be the expected resistence? what about the solenoid? if the solenoid is fault, doesnt it mean that water from the pump will not flow into the thermoblock? if yes, how to test the solenoid? .https://drive.google.com/file/d/1-VuztzxgvxRNP_-ukJYMJYoaUw_oUn3B/view?usp=sharing Thanks Assaf
×
×
  • Create New...