Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral

About Stetran

  • Rank
    Green Bean

Your Profile

  • Location

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I opened up the switches to have a look inside, the terminals inside look like they got jolted out of position from the shock. Now that they've been put back in place, the switches are clicking like they were before and are switching correctly. They did look a little tainted but still work. I actually just plugged everything back in, minus mecoffee and she powered up and is working!!!
  2. Hello, Thanks for your reply. The temperature was going way above 125 when the steam button wasnt on. For example, I'd turn the machine on and leave to do something else and when I went to pull a shot, the water temp would be way too high. It was why I thought I would take a look at the wiring. I'm pretty sure I must have fudged the wiring which caused the house circuit breakers to jump. There was a spark at the plug socket. I tested the sensors and what I believe is the heating element (two terminals on top of the boiler) which I think are fine. I think the lamp next to the On/Off switch is gone though which is annoying as I didnt order a new one! The mecoffee pid has been great for me but I think the constant heating up and cooling down may have affected it. A lot of the wires have become brittle/stiff. Anyway, I've ordered a replacement Auber PID which is on the way so hopefully nothing is dead. I will check the boiler and other parts again, wasnt sure if I did it right. Thanks again!
  3. I was fiddling around the the mecoffee pid I had installed as it was heating the water to way over what it should be (125c), then when I put it all back together the circuit breakers jump. I also saw a flash from the plug socket, one of the pins has some black marks. Just from looking nothing seems to have broken, nothing smells. However the On/Off switch doesn't click properly anymore. When you push it, it doesn't set into the other position and has a spongy bouncy feel. The brew button is the same. The other 2 buttons are still fine. I found a resource that tells me how I can test each part to see if they're still working but I need to grab my multimeter from work first. Am i going down the right road in fixing this? Also is it possible to get replacement wires for the internal connections? The heat from inside has possibly damaged some. Thank you
  • Create New...